NO response by tinymovr studio on operating a bldc motor, tinymovr R5.3 with canine v1.4 adapter

[TayyabAsim047]

Tinymovr Version: R5.3
BLDC Motor Model: [JD-power DCH-6829F flat dc hollow shaft brushless motor with switch hall sensor]
Bus Interface: [SLCAN]
Tinymovr Studio Version: [2.3.2]

Issue Description:
I am using a Tinymovr R5.3 board to control a BLDC motor via Tinymovr Studio, but I am not getting any response when sending commands. The board is detected, and communication over [CAN/SLCAN] is established successfully. However, when issuing movement commands, the motor does not move, and there is no feedback in Tinymovr Studio.

Expected Behavior:
The BLDC motor should rotate based on the commanded setpoint, and Tinymovr Studio should provide real-time feedback.

Observed Behavior:
No motor movement
No output or error messages in Tinymovr Studio
Board appears connected but does not execute commands

Troubleshooting Attempts:
Verified power and wiring connections
Confirmed motor parameters (resistance=1.6ohm, inductance=2.11mH, pole pairs=11)
Tested different bus interfaces (tinymovr_cli shows device, but no control)
Reinstalled Tinymovr Studio and drivers

Any guidance on debugging or further troubleshooting would be greatly appreciated. Thanks!

[yconst]

Please post the motor parameters including errors.

Please note that Tinymovr R5.3 does not support motors with internal resistance > 1Ohm

[TayyabAsim047]

The motor is showing some rotations only in Calibration mode but not working in position and velocity mode, the state remains IDLE in position and velocity mode without any error on studio. The motor specs are [(resistance=1.6ohm, inductance=2.11mH, pole pairs=11)]

[yconst]

Please note that Tinymovr R5.3 does not support motors with internal resistance > 1Ohm

[yconst]

Converting this to a discussion