Created a custom hook using the MulticonnectHook.scad model as I needed a modified hook to hang some wall mounted leftover bins I had.
Finally got the size right for the bin and went to mount it onto my openGrid wall using Multiconnect and found that the spacing was off.
Read through and found
Multiboard Snaps
Creates compatibility with the multiboard system.
Note: This allows you to add multiboard connection points to openGrid, having those will be completely sufficient for single snap applications. If you want to use mode that one grid tile for attachment the different grid sizes (28mm vs. 25mm) will create additional challenges. There are also models out there to mitigate this grid difference.
From the website guide.
Went to go adjust to "custom spacing" and noticed the other models had a "Slot Connection Type"
I may not have researched everything well enough - but could have sworn everything was cross compatible.
I just hung up my openGrid on the wall so still learning - figured I would make an issue since I saw that mentioned in the comments
Created a custom hook using the MulticonnectHook.scad model as I needed a modified hook to hang some wall mounted leftover bins I had.
Finally got the size right for the bin and went to mount it onto my openGrid wall using Multiconnect and found that the spacing was off.
Read through and found
From the website guide.
Went to go adjust to "custom spacing" and noticed the other models had a "Slot Connection Type"
I may not have researched everything well enough - but could have sworn everything was cross compatible.
I just hung up my openGrid on the wall so still learning - figured I would make an issue since I saw that mentioned in the comments